Bathtub to Shower Conversion Checklist Dubai
A bathtub-to-shower conversion checklist should begin with the intended user and the existing bathroom. Record entry, reach, support and seating needs, then connect them to the measured wet area, drainage, floor build-up, waterproofing, fixtures, screen and property requirements.
Published
Written byFaraaz ZahidLead Project Engineer
What to check before removing the tub
Describe who will use the new shower and what is difficult about the existing tub. Then record dimensions, door and fixture positions, drain location, floor levels, ventilation, visible damage and the selected shower components. This gives the survey a clear decision task rather than a generic request for a walk-in shower.
A product described as walk-in or low-threshold does not automatically meet one person’s needs or a particular standard. Entry, clear space, reach, grip, support, seating and assistance should be considered for the actual user and property.
- User movement, reach, support and seating brief
- Bathroom, tub-zone, door and fixture dimensions
- Drain, pipework, floor build-up and ventilation information
- Waterproofing and retained-finish boundaries
- Selected fixtures, screen, tray or floor approach and accessories
Conversion planning file
Record the actual use rather than relying on an accessibility label.
Include photographs and level changes.
State what is visible and what still requires investigation.
Resolve interfaces as one connected construction.
Check the actual property before scheduling.
Plan the conversion in sequence
- 01
Write the user task
Describe present difficulty and the desired shower or bath use.
- 02
Survey the bathroom
Measure fixtures, openings, floor levels and visible services and note building constraints.
- 03
Choose the route
Compare a walk-in shower, low-threshold shower or selected walk-in bath against the user and room.
- 04
Select products
Confirm dimensions and installation information for the drain, tray, screen, controls, fixtures and accessories.
- 05
Define hidden work
Document investigation, substrate repair, drainage, backing and waterproofing boundaries.
- 06
Confirm handover checks
List the agreed water, drainage, sealant, screen, ventilation and product-information checks.
Decisions to close before work begins
| Decision | Decision recorded | Risk if unresolved |
|---|---|---|
| Entry detail | Measured tray, threshold or floor build-up | Unexpected step, drainage conflict or unusable entry |
| Screen geometry | Opening, swing or fixed-panel dimensions checked | Splash, circulation or fixture conflicts |
| Support locations | User needs and wall backing coordinated | Accessories fixed to unsuitable wall construction |
| Waterproofing boundary | Connected system and retained interfaces documented | Ambiguous patching or unpriced finish replacement |
| Product data | Selected models and dimensions recorded | Late service, opening or access changes |
Conversion planning FAQ
01Can a low-threshold shower always be installed?+
Not automatically. The available floor build-up, slab, drain route, required falls, waterproofing and property constraints must be checked before the entry detail is confirmed.
02Where should support rails be positioned?+
Positions depend on the intended user, movement and selected layout. Suitable backing and fixing should be coordinated before finishes conceal the wall construction.
03Does this checklist certify an accessible bathroom?+
No. It helps record user and technical decisions. Any project-specific accessibility, regulatory or clinical requirement needs appropriate assessment and confirmation.